User Tools

Site Tools


iotivity_protocol_conformance_test_guide

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
iotivity_protocol_conformance_test_guide [2018/02/08 11:17]
Sankar Selvam R [Pre-Condition]
iotivity_protocol_conformance_test_guide [2018/02/08 11:18] (current)
Sankar Selvam R [Pre-Condition]
Line 53: Line 53:
  
 General condition for all sections: General condition for all sections:
- +  ​* When CTT prompts "​Please manually perform a factory reset on the IUT and confirm when complete",​ Just press enter and continue. 
-* When CTT prompts "​Please manually perform a factory reset on the IUT and confirm when complete",​ Just press enter and continue. +  * During WES test Cases, Factory reset means, you need to reset the IUT and make sure its boot with its SoftAP. 
-* During WES test Cases, Factory reset means, you need to reset the IUT and make sure its boot with its SoftAP. +  * If CTT prompts "​Please initiate device to revert to 'ready for OTM' state",​ Reset the IUT and Continue. (Give the same command used earlier bring-up IUT should be followed to reset)
-* If CTT prompts "​Please initiate device to revert to 'ready for OTM' state",​ Reset the IUT and Continue. (Give the same command used earlier bring-up IUT should be followed to reset)+
 ==== CT1.1.1 to CT1.2.3 ==== ==== CT1.1.1 to CT1.2.3 ====
   * Select desired TCs from **Test(s) List**   * Select desired TCs from **Test(s) List**
iotivity_protocol_conformance_test_guide.txt · Last modified: 2018/02/08 11:18 by Sankar Selvam R